Ford Power Stroke Nation banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
The Unseen Mod
Joined
·
4,126 Posts
Discussion Starter #1
To begin this mod, You will need a long flat head screw driver, a phillips heads, and a cutting tool of your choice, saw zaw, or hole saw can work as well. Removal of the airbox is a good idea as well give you room to cut through.

Step 1

Start by removing the 4 screws located on thop of the Grill, here shown in picture one for locations. Using the Phillips Head Screw Driver


Step 2

Next using the flat head screw driver run it between the grill and bumper, your going to want to lift these tabs and pull the grill out a little to have it pop out, there are 4 located under the grill.


Step 3

Location of the hole is shown in picture below, size and shape can be done by the owner, I just hacked mine out no big deal, if you want to take the time have at it. This part of the header panel is located on the driver side between the out edge of the header panel and condensor. Shown in the next photo.


Full View



Once your hole is cut reverse the steps of removing the grill, place the bottom of the grill in first press slightly left to right, or Right to left making sure each tab is snapped into place, once completed reinstall the 4 screws located on top.
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top