Ford Power Stroke Nation banner

1 - 3 of 3 Posts

·
Registered
Joined
·
3,379 Posts
Discussion Starter #1
Hey Guys,
Apologies for the pester but I can’t seem to find torque spec for bolting the ZF S5-47 to the BW 4407 transfer case. Did a search here and at PSA... no results and googled too, nuthin. Also need specs for ZF bell housing to block torque specs would be most helpful. Probably over thinking but they are all cast aluminum (save for the block), and not wanting them to come loose the notion is to over tighten and strip..... doh... thinking I’ll use blue locktite on the Tranny to Tcase bolts as well a size drive line bolts...
Thanks in advance.
j
 

·
Registered
Joined
·
5,701 Posts
According to my manual the transfer to transmission bolts are 30-40 ft/lbs. Tightened in a star pattern.

The transmission to engine bolts are 39-53 ft/lbs.

It doesn't say anything about loctite or antisise on either.
 

·
Registered
Joined
·
3,379 Posts
Discussion Starter #3
Thanks Bugman... confirms what I found. Finally remembered I have a digital shop manual in my Dropbox account, knew I had one somewhere, was just locating it... bahahahaa

Transfer Case to Transmission Extension Housing 41-54Nm 30-40 lbs ft.
The T case to extension did have loctite on the threads from factory, engine to tranny I’d say none.
Thanks again
j
 
1 - 3 of 3 Posts
Top