Ford Power Stroke Nation banner
1 - 1 of 1 Posts

·
Registered
1996 F250 XLT
Joined
·
30 Posts
Discussion Starter · #1 ·
I'm in the progress of upgrading to the 6.0 oil cooler on my '96 when I noticed coolant seeping around the top plastic end cap (I hate those plastic end caps - this is the second radiator I've had of that type that failed there). I plan on ordering the XDP XD468 radiator to replace the radiator, a one piece aluminum radiator. I bought a 1/4" NPT to 1/2" barb adapter I was planning on using in the old radiator for the 6.0 transmission cooler. I noticed the XDP radiator has threaded fittings for the transmission cooler fittings - does anyone know if these are also 1/4" NPT? I've sent XDP email, but it appears everyone's customer support is seriously backed up these days....

Thanks.

EDIT: I just received an email response from XDP - they said it's the same size as the OEM size fittings; I hope they mean thread size. I guess I'll order it - worst case I use two 5/16" to 1/2" barb adapters.
 
1 - 1 of 1 Posts
Top