Ford Power Stroke Nation banner

1 - 2 of 2 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
Hey All
I'll be replacing the up pipes this summer on my '01 F350; will be using a kit with bellowed pipes and a new pedestal with the EBPV delete. I figure it's a good time to at least replace the turbo wheel to a non-surging type, and upgrade to a 360* bearing.
Would it be worth getting a 66/88 housing with 4" hose, new waste gate actuator, etc? I do have a 6-position chip installed, but am not planning on any additional mods. Truck does have EGT, boost, and trans temp gauges on the A-pillar installed by a PO.

If I pick up the 66/88 housing, are any other mods needed to install it?

Thanks!
 

·
Registered
Joined
·
1,013 Posts
I know it’s worth it. I have it in my single cab. I have stock injectors, intake and exhaust, and hydra. Made the truck run so smooth and towed so much better. Better than spending 1200-1500 on a new kcturbo. I have the kcturbo too - best money spent (only when you have money).


—————signature—————
~Don’t overthink something simple~
...:uptight people suck:...
 
1 - 2 of 2 Posts
Top