Ford Power Stroke Nation banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2,897 Posts
Discussion Starter · #1 ·
I have a bandsaw with a two speed 110v motor. There are two seperate fields that feed the motor with three large wires and one small wire for each field.

I am trying to eliminate all e-stops, speed selector and enable button. Saw is a Kama 996, attached is the electrical schematic.

I want to wire it to run high speed only with a simple on off switch. The controls were nice, but did not like to travel and were always broken or loose.
 

Attachments

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top