Ford Power Stroke Nation banner

1 - 5 of 5 Posts

·
Registered
Joined
·
202 Posts
Discussion Starter #1
well today my saftey switch went out and while i was replacing it i did the "permanent clutch problem fix" to replace to plastic bushing...


well it didnt fix he problem. its hard to down shift the truck and i cant get it into gear sitting at idle.

i noticed today under the dash the back of the clutch master cyl was leaking a little.

from some research ive done the clutch master cyl could be causing my problem. and i would like to fix this problem before the trans get damaged.

heres a link to a master cyl i thought of buying


Zip Code Select | O'Reilly Auto Parts
 

·
Registered
Joined
·
290 Posts
i got the napa master cylinder. its pretty nice and was priced well.

it definetly sounds like the clutch isnt disengaging all the way. i would advise you dont drive the truck if its that bad. youll tear up your synchros QUICK!
 

·
Registered
Joined
·
202 Posts
Discussion Starter #3
so you think i should i get clutch master cyl?
 

·
Strokin'
Joined
·
113 Posts
so you think i should i get clutch master cyl?
With it leaking i would change it.

as for not getting it into gear.. do you have a full pedal or is it low/closer to the floor? Has the clutch, pressure plate, throw out bearing etc been change?

I myself wouldnt reccomend driving the truck if it grinds when trying to put it in gear at and idle.
 

·
your mom
Joined
·
211 Posts
change it if its leaking.
 
1 - 5 of 5 Posts
Top