Ford Power Stroke Nation banner
1 - 2 of 2 Posts

·
BRING DA AMBALAMPS
Joined
·
1,955 Posts
Discussion Starter · #1 ·
Ok, I'm starting to put together a list of parts needed to mount up some traction bars. For the DIY'ers, where did you get your mounting hardware (joints, brackets, etc)? I've seen the procomp mounting kit but i noticed that it will basically put the rear of the bar right in the middle of the axle. does it make a difference in axle wrap resistance if the brackets are hung off the bottom like most or if they're in the middle or even on top of the axle? I'm totally foreign to this whole trac bar thing so a list of materials or a place to buy a mounting kit would really help. Gracias!
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top