Ford Power Stroke Nation banner

1 - 1 of 1 Posts

·
Registered
Joined
·
299 Posts
Discussion Starter #1
Hey all,

I put new wheels on my truck on Friday. Re-used the sensors I had in my old wheels with the new BMF's.. Truck was fine until yesterday and then the message center says "Tire Pressure Monitior Fault" and the yellow light flashes then goes solid.

It's not telling me they are low pressure, and when I try to do the train procedure it fails. Maybe one of the sensors are bad?

I know on the F250 when I switched the wheels over, it did the same thing, but the next ignition cycle the light went out, and never came on again.

Anyone have this happen to them? I'm going to call the dealer tomorrow and see if they can plug onto it and see what's up.

Thanks.
 
1 - 1 of 1 Posts
Top