Ford Power Stroke Nation banner

1 - 3 of 3 Posts

·
Registered
Joined
·
825 Posts
Discussion Starter #1
Emailed Joey but haven't heard back. The oil line that runs from the Remote IPR to the reservoir is leaking and was wanting to replace it with braided SS. I presume if I use the same diameter I am fine. What about pressure and heat? Also would like to replace the HP lines to the heads so they will fit better. What should I use for those?
 

·
Registered
Joined
·
5,909 Posts
Greg, check your spam box. I did respond, yesterday. :doh:

The R-IPR is 1/8" pipe and the reservoir end is -4 JIC. The hose needs to be rated 300 degrees and above 250 psi.

Shoot me your address and I'll mail you a new line. :D

On Edit: My mistake Greg.:doh: The email came through a secure server and was mailed back the same way(Tuesday morning). I didn't notice until this morning. Now you have you an email.
 
1 - 3 of 3 Posts
Top