Ford Power Stroke Nation banner

1 - 8 of 8 Posts

·
The Unseen Mod
Joined
·
4,126 Posts
Sorry if Im asking a dumb question and the gains or purpose out of this ? where are pictures, would this be better for the trans ?
 

·
The Unseen Mod
Joined
·
4,126 Posts
NVM I see that its only for 7.3l's
 

·
Back to Civilian Life!!
Joined
·
2,469 Posts
I found my next mod. Going to go and do this. I could use it when I am on my higher HP seetings on my chip.
 

·
AllYourBaseAreBelongToUs
Joined
·
13,954 Posts
When I had my mini-me injectors and Garrett bb turbo I dropped 3 tenths in the 1/4 mile with this mod. And it's a MUST HAVE with my current set-up.
 

·
USN-Retired
Joined
·
145 Posts
Sorry if Im asking a dumb question and the gains or purpose out of this ? where are pictures, would this be better for the trans ?
Being a person that marches to a different drum beat, I used a regular pilot light instead of an LED. Also, since I did the BTS thing over 4K before even my factory warranty was up I never have had a temp or braking issue towing on the downhills and am not a dragstip kind of a guy so for me the manual tranny L/O was not IMHO needed. I tapped into the factory wire for ckt 480 bundle about 4 inches from where my ISSPRO tranny temp sensor is located in the NPT test port on the drivers side of the trans. I then ran the wire into the tranny temp sensor wire loom I installed and ran it into the inside of the vehicle along the parking brake cable access. This wire then goes into a small plastic box located in the area under the drivers side steering wheel area thru a .063A fuze - smallest I could find so far - and then used it to provide a ground for a Radio shack reed relay (#275-233) both of which are packaged in this plastic box. The output of this relay then goes to a switch with resistors to provide a bright and dim voltage to the pilot light located in the A-pillar pod which houses my tranny temp guage. I was concerned with protecting that circuit since it is an input/output of the PCM and wanted to protect the PCM from any overload or shorting problems with my backyard wiring. Overkill probably, but that's just me :redspotdance: I mounted my indicator light in the A-pillar gauge pod HERE . That turn signal thingee has saved me from driving downing the freeway blinking away many a time.

Larry
 
1 - 8 of 8 Posts
Top