Ford Power Stroke Nation banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Hey all,
My name is Dustin and I am 17 and looking for some help with my Cummins and manuel NV4500 swap.

I have the engine and trans in the truck but they need mounts.

And I was wondering if you guys knew how to build some custom ones or knew a place that had mounts for good deal? I have looked at Carrick Customs and DCS (Diesel Conversion Specialists) but I'm from Alberta Canada and I obviously need to convert USD into CAD and the prices do add up.

I also was toying with the idea of putting the cab,
box and front end on a super duty chassis. Any one know how hard it is? I have a 210 Millermatic Mig welder and a stick welder for welding mounts if I need too.

Any ideas and suggestions would be greatly appreciated. Thank you.
 

·
Registered
Joined
·
5,809 Posts
I don't know if they might have what you are looking for but check out Destroked


And Diesel Conversions

 

·
Registered
Joined
·
42 Posts
Hey all,
My name is Dustin and I am 17 and looking for some help with my Cummins and manuel NV4500 swap.

I have the engine and trans in the truck but they need mounts.

And I was wondering if you guys knew how to build some custom ones or knew a place that had mounts for good deal? I have looked at Carrick Customs and DCS (Diesel Conversion Specialists) but I'm from Alberta Canada and I obviously need to convert USD into CAD and the prices do add up.

I also was toying with the idea of putting the cab,
box and front end on a super duty chassis. Any one know how hard it is? I have a 210 Millermatic Mig welder and a stick welder for welding mounts if I need too.

Any ideas and suggestions would be greatly appreciated. Thank you.
Put it back in the Dodge and you will have a better truck...
 
1 - 4 of 4 Posts
Top