Ford Power Stroke Nation banner

1 - 7 of 7 Posts

·
Registered
Joined
·
207 Posts
Discussion Starter #1
I am doing a straight axle swap on my 97 f-250 and i have a couple questions. Will my stock driveshaft work or will i have to get it changed? And I see where people do shackle reversals and i was wondering what was all involved in this cause i would like to do it now if its not too hard and how much does it help? and does it lift it and by how much on the shackle reversal?
 

·
Registered
Joined
·
207 Posts
Discussion Starter #4
thanks thats what i wanted to hear. And i have the blocks and the springs for the rear so all is good there. Is ther any benifit to doing a shackle reversal in the rear?
 

·
Registered
Joined
·
4,810 Posts
Drive shaft isn't the same as a F350-D60 should use a CV front shaft..you can use the F250 shaft but angles are not what is recomended.

I do not recomened a RS for the rear. RS kit front with V codes and B codes rear will transform the ride. I developed this mod 8 years ago and have help hundreds do this. I have everything needed. PM me if I can help.

Cary
 
1 - 7 of 7 Posts
Top