Ford Power Stroke Nation banner

1 - 4 of 4 Posts

·
Registered
Joined
·
131 Posts
Discussion Starter #1
I have a 180/150 fass and I was wondering if there was a sponsor on here that could sell me all the lines and fittings I need to run from the fass 1/2 line then Y to 3/8 and feed the heads. I also need to buy a Auto meter z series fuel guage and electric sender. I also need gauge mount for steering column. I may also get a crossover line for the rear of the heads. The fuel line can be rubber line. Any help would be appreciated.
 

·
Registered
Joined
·
5,891 Posts
earl's fittings( I believe) would be your best bet for the lines to feed the heads..

I could assit you with the fuel pressure gauge, pod and rear crossover line.
 

·
6.0 money pit
Joined
·
3,107 Posts
:whs:

building your own lines would rezuire very few fittings and it will be the way YOU want it. im not even sure if there is anyone that makes one that wont cost you an arm and a leg.
 

·
Registered
Joined
·
1,473 Posts
I've been looking at building my own lines, but haven't found a source for the good Teflon-lined fuel hose.
 
1 - 4 of 4 Posts
Top