Ford Power Stroke Nation banner

1 - 5 of 5 Posts

·
Registered
Joined
·
142 Posts
Discussion Starter #1
I replaced my flywheel and clutch, got the tranny, driveshaft and starter back in. I just can't get the pushrod in on the slave cylinder to stay in long enough to install it between the mounting bracket and clutch fork..... GRRRRRGH!! Anybody have any suggestions?? '95 F350 7.3L psd ZF5 TIA!
 

·
Registered
Joined
·
797 Posts
I used a pullback ram with my porta-power to draw the clutch fork back.
 

·
OverFuelingForYourPlesure
Joined
·
1,609 Posts
i ususaly just push it up against the fork at an angle to get the rod back in the slave cylinder then just snap it on the transmission as I go up.

I guess you could break the bleeder loose to make it easier but then you would have to bleed it again.
 

·
Registered
Joined
·
142 Posts
Discussion Starter #5
I got it! used ratchet strap. Thanks PSN for all help throughout the process! We have succeeded! New single mass flywheel and clutch kit and rebuilt ZF5! I'm lovin' it! The ol'e horse is back on the road!
 
1 - 5 of 5 Posts
Top