[bbbxcursion]

Hey there. This all started a couple weeks ago when I did a burnout, I fried new tires in one LONG burnout. Anywho, I fried the H2E so I installed Beans H2E. I also replaced the up-pipes and donuts while I was in there. Since that night of the burnout, the truck smokes like a train trying to pull away from a stop light. The truck also stalls occasionally when I go from park to drive. This is all new stuff that happed after I fried the tires. New fuel filter, Oil Change, ICP sensor, and IPR valve replaced. Anyone have any ideas? What would cause the stalling issue? It's not the DP chip, I put in a TS chip and same stuff happens.

 

[gregrob]

torque converter lockin up.

bet you did a number on it

 

[bbbxcursion]

I hope it aint the converter, just installed a BTS a couple months ago! I will never do a burnout after a 'few' drinks again. How would I know if this is a trans problem?

 

[gregrob]

I would talk to Brian if you have a BTS, he can recommend what to check better than I can.

I would at least check your fluid, see if it's low, looks burned, etc.

 

[bbbxcursion]

Level good, looks like new. I'll try calling him tomarrow, hope they pick up the phone.

 

[bbbxcursion]

BTS rocks! They are sending me a new torque converter ASAP!

 

[gregrob]

saweet, figured it was a TC issue.

 

[Dzacc]

I had the same problem after 3 years of driving it but it only did this in cold weather after the truck wasn't driven for a week. After warming up, the TC was fine. Brian rebuilt the whole tranny better than the first time for the tidy sum of $0,000.00. :rockwoot:

DZ

 

[bbbxcursion]

BTS service rocks, I could not be any happier with their service.