Ford Power Stroke Nation banner

1 - 2 of 2 Posts

·
Registered
Joined
·
365 Posts
Discussion Starter #1
I’m sure it’s been asked a ton of times, but I can’t find it. I’m looking at a new rim/tire set up for my 01 dually. It currently has a 2” level and is getting bags in the rear in the near future and is sitting on the stock 16” rims with 285/75 MT’s with 2” spacers in the rear. Main reason I’m looking for new stuff is to change things up a bit. So my question is, how much cutting of the front fender well will be required to fit 35/12.50x20’s on fuel cleaver’s? Thanks!


Sent from my iPhone using Tapatalk
 

·
Administrator
Joined
·
8,238 Posts
Without crazy offset no trimming of the fender is needed. You may need to trim the wheel well liner and front valance
 
1 - 2 of 2 Posts
Top