Ford Power Stroke Nation banner

1 - 6 of 6 Posts

·
Registered
Joined
·
49 Posts
Discussion Starter #1
Where can I find the bolt sequence and torque specs for installing the intake manifold? Also, the inside of my intake is completely covered with soot. 220,000 miles of it. I want to clean it but not harm the aluminum or machined surfaces. I have a couple of days to do this. Should I send it out to a shop? Thanks.
 

·
Registered
Joined
·
689 Posts
I put my intake manifold in a large bucket full of purple power, ajax, dish washer soap, and one other cleaner I forget, for 5 days. I sprayed it with a hose here and there durring the 5 days to remove what the cleaning solution loosend up. It came out very clean.
 

·
Registered
Joined
·
1,459 Posts
check all data........

as far as cleaning it, my friend put mine into the parts washer at work for a bit, came out looking really good!
 

·
Hood Rich
Joined
·
2,873 Posts
just make sure you install the intake gaskets with the knurles facing up and towards each other,on the inside.... I use 2 bolts on each side to hold the gaskets to the manifold while dropping it in
 

·
Registered
Joined
·
49 Posts
Discussion Starter #6
Thanks lenzhotrod, that is just what I needed. Printed and in my truck binder.
 
1 - 6 of 6 Posts
Top