Ford Power Stroke Nation banner

1 - 2 of 2 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
Whats the steps to program a key fob on a 96 f250 slt? i have power everything, just picked up a fob and the instructions I have read this:

"1. Turn ignition to RUN or ACC.

2. Momentarily jump pins in programming connector located at the base of the steering
column. All doors will lock then unlock to confirm programming mode.

3. Press any button on first keyless remote. Door locks will cycle to confirm programming.

4. If programming a second keyless remote, press any button on second keyless remote.
Door locks will cycle to confirm programming.

5. Turn igniton to OFF. Locks will again cycle to indicate end of programming mode."

But step 2, I don't see where the connector is at steering column base to jump.
 

·
Powerstroked
Joined
·
602 Posts
Stupid question: You're sure that the truck was equipped with keyless entry? Just because you have power options does not mean you have keyless entry.

Check this thread out first, as it describes how to tell if the truck is even equipped with keyless. I think the description of the location of the keyless module (if you have one) might help you locate those pins
http://powerstrokenation.com/forums/showthread.php?t=47092
 
1 - 2 of 2 Posts
Top