Ford Power Stroke Nation banner

1 - 3 of 3 Posts

·
Registered
Joined
·
228 Posts
Discussion Starter #1
So ordered all new fuel filters to install. I am running 1/2" lines from sump to napa 3528 filter, then to my 6.7 pump then to a regulated return. After changing both filters i didnt get the housing tight enough, so it sucked air and truck shut off. Long story short it will not pump fuel now. I hear the pump turn on and run, but no fuel. Could i have screwed the pump up? I know its a rookie mistake, didnt realize to tighten the housing to the stops. I was pretty snug with it tho, didnt require more than one turn.

Sent from my SM-S727VL using Tapatalk

Sent from my SM-S727VL using Tapatalk
 

·
Registered
Joined
·
1,418 Posts
Wrong section...you're in the 6.0
 

·
sooty
Joined
·
409 Posts
It probably has air lock. You need to bleed it somehow.

You would know how to best as your setup isnt factory
 
1 - 3 of 3 Posts
Top