Ford Power Stroke Nation banner

1 - 5 of 5 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1 (Edited)
hello there, not sure if I'm doing this right cause I'm new but here we go. I have a 2005 f250 6.0l that I had some steering problems with so I replaced tie rod ends, steering stabilizer, steering gear box and power steering pump. Im having issues turning the wheel when im siting still, is this normal? I think I bled the system correct, had the truck on stands and rotated the wheel lock to lock like 30 or 40 times. Thanks in advance! 156000 miles, 35in tires
 

·
Registered
Joined
·
289 Posts
Try it with the wheels off the ground? Frozen ball joints can be an issue also. Can disconnect the drag link and stabilizer and try turning by hand
 

·
Registered
Joined
·
2 Posts
Discussion Starter #5
Off the ground when I was bleeding it, it turns great with one finger, as soon as I set it down, it locks up until I give it throttle or start to roll
 
1 - 5 of 5 Posts
Top