Ford Power Stroke Nation banner

1 - 4 of 4 Posts

·
Registered
Joined
·
162 Posts
Discussion Starter #1
02, 7.3 I was planning to install oil press gauge in the plug by the bell housing, to the rear of the oil filter.....trying to find the right size reducer..the fitting on the capillary tube from the gauge is 1/8" , the hole in the block is either 3/16" or 1/16" not...but I can't find either..any help? Thanks, rsbhunter
 

·
Registered
Joined
·
162 Posts
Discussion Starter #2
02, 7.3 I was planning to install oil press gauge in the plug by the bell housing, to the rear of the oil filter.....trying to find the right size reducer..the fitting on the capillary tube from the gauge is 1/8" , the hole in the block is either 3/16" or 1/16" npt...but I can't find either..any help? Thanks, rsbhunter
 

·
Smoke 'em if ya got 'em.
Joined
·
145 Posts
Ya I don't think they make such a thing as 3/16 or 1/16 npt.
 
1 - 4 of 4 Posts
Top