Ford Power Stroke Nation banner

1 - 4 of 4 Posts

·
Justaworktruck
Joined
·
396 Posts
Discussion Starter #1
What do I use to refasten the inside door panels, most screws will not tighten anymore.
 

·
Fire junkie
Joined
·
536 Posts
Most have the plastic push pin style, along the bottom I had a few screws that would not get tight, just went with one that was just a hair bigger to get it tight
 

·
Demon Dually
Joined
·
5,140 Posts
What normally happens is that you cause the metal to bow outward around the hole which then prevents the screw from tightening. If you use a body hammer and dolly to flatten the area around the holes back out you will find that the screws will tighten back down.
 

·
Justaworktruck
Joined
·
396 Posts
Discussion Starter #4
I know the OBS lower door panel screw are known to come out, I am planning to use nut rivets.
 
1 - 4 of 4 Posts
Top