Ford Power Stroke Nation banner

1 - 5 of 5 Posts

·
compresion ignition adict
Joined
·
209 Posts
Discussion Starter #1
Swappin in a 24 spline input on my existing transfer case to work with the zf6 i swapped in my truck... anyone done this before... i have the parts and will be tryin this either tomorrow or some other day this week. Was wondering if there is anything i should do to help in doing this. Anything specific i need to do when instaling or removing the old shaft and gear?
 

·
Registered
Joined
·
284 Posts
its pretty straight forward, you will need to remove the front driveshaft yoke and seal to get at a snap ring behind this, then just split the case in halves and remove everything in the front half to get at the input. just pay attention to how everything comes apart
 

·
Registered
Joined
·
14,569 Posts
If you could maybe take some pictures... That would be awesome. I have a manual shift 6 speed T-case, but I need a manual shift AT T-case....
 

·
compresion ignition adict
Joined
·
209 Posts
Discussion Starter #4
Ended up having the guy thats working on my ZF6 take a whack at it.... im so bussy tryin to finish up this cummins conversion i really dont have the time... hope it all works out though.
 
1 - 5 of 5 Posts
Top