Ford Power Stroke Nation banner

1 - 6 of 6 Posts

·
Registered
Joined
·
138 Posts
Discussion Starter #1
i am replaceing my turbo next week and have a new set of injectors have never done eather the turbo looks pretty cut and dry can someone give me some insite on replaceing the injectors dont realy want to pay 300$ to have some one else do it if i dont have to thanks.
 

·
just a welding fool.
Joined
·
1,097 Posts
it isn't bad. i found that instead of the vacumm trick to get the fuel out of the cylinders, i just placed a rag over the injector hole and stuck a long air nozzle down in there, blew out all the excess fuel. when you pull the oil rail plugs, a turkey baster works good to push air through one hole to get the oil out the other. make sure everythign is torqued down too.
 

·
Headwind Magnet
Joined
·
626 Posts
Check out the 7.3 library for a couple of videos that are helpful.
Best,
Jim
 

·
Registered
Joined
·
138 Posts
Discussion Starter #5
Thanks guys I will take a look at the videos I did look at swamps site what are they to be torqued to ?
 

·
Headwind Magnet
Joined
·
626 Posts
Thanks guys I will take a look at the videos I did look at swamps site what are they to be torqued to ?
Swamps includes the torque settings in their instructions.
Best,
Jim
 
1 - 6 of 6 Posts
Top