Ford Power Stroke Nation banner

1 - 9 of 9 Posts

·
Registered
Joined
·
403 Posts
Discussion Starter #1
So i have a bulb in my speedometer between the 30mph and 60 mph out. Does anyone have a walk through on how to replace it and where to get the bulb?
Thanks.
 

·
Registered
Joined
·
15,561 Posts
pull the trim pieces off to get to the two screws that hold the bigger piece of trim on, unhook the switch for the tanks, unhook the wires going to the wait to start and water in fuel lights. then remove the 4 screws that hold that hold the gauge cluster, unhook the wire harness that hooks into the back of the cluster. on the back you will see all the bulbs. that are just a twist lock.
 

·
Senior Veteran Member
Joined
·
937 Posts
Not too hard to do, just be careful not to lose the little clips that hold the horizontal trim pieces on that you must remove in order to get tothe screws that hold the bezel in place.
 

·
Registered
Joined
·
403 Posts
Discussion Starter #4
Wow alot of work for one bulb. But it has to be done. Where can i get the bulb?
Thanks guys.
 

·
Haters Gonna Hate
Joined
·
5,869 Posts
its not really that much work, can be done in about 10-15 minutes and the with disassembly and reassembly
 

·
Registered
Joined
·
2,761 Posts

·
Registered
Joined
·
403 Posts
Discussion Starter #9
Nice writeup. Thanks guys!
 
1 - 9 of 9 Posts
Top