Ford Power Stroke Nation banner

1 - 10 of 10 Posts

·
Registered
Joined
·
195 Posts
Discussion Starter #1
i took my transmission out today to put a main seal in. i reinstalled the trans and now it wont pull when i put it into gear. all the torque converter bolts are in. the transfercase is in gear everything is hooked up. but i get no respone when i shift into gear. the overdrive light isnt flashing. my shift linkage is shifting. i got plenty of fluid in it. im confused as to what it could be it was working fine when i parked it. is the a fuse under the hood that controls it? all the one in my dash are fine. any help would be great!:confused:
 

·
needs more fuel
Joined
·
697 Posts
everything plugged in good? buddy of mine put a front seal in and forgot one of the plugs. wouldnt pull at all
 

·
Former Ford Trans Engr.
Joined
·
3,150 Posts
There is nothing electrical that could do this. Even if everything is unplugged the trans will still engage and move the truck.

How much is "plenty" of fluid? Where does it read on the dipstick?
 

·
Registered
Joined
·
195 Posts
Discussion Starter #4
reads full on the dipstick with the truck running
 

·
Registered
Joined
·
1,557 Posts
did you get the convertor in right?
 

·
Former Ford Trans Engr.
Joined
·
3,150 Posts
It's possible that the internal filter fell off. That sometimes was a problem in the E4OD.
 

·
Registered
Joined
·
195 Posts
Discussion Starter #7
u mean the internal filter in the pan?
 

·
Former Ford Trans Engr.
Joined
·
3,150 Posts
Yes.
 

·
Registered
Joined
·
195 Posts
Discussion Starter #9
thanks Mark i took the pan off this morning and that was the problem everything works great now.
 

·
needs more fuel
Joined
·
697 Posts
so when is my test drive? :D
 
1 - 10 of 10 Posts
Top