Ford Power Stroke Nation banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,396 Posts
Discussion Starter #1
My 97 TTB is in the junk pile and my 02 superduty axle is ready to be finished. The Mile marker site has the same hub fitting both axles. Does this mean the TTB hubs will fit on the superduty? If not is around $150 plus the conversion kit a good price for the milemarker? Thanks, Don
 

·
Registered
Joined
·
3,368 Posts
Pretty sure its the same hub, try it and see!
FYI your TTB was a dana 50 your new SD axle is a dana 50 also

Milemarker 449SS kit runs about $150 new comes with everything you need to install
You do not need the conversion kit unless you are switching from auto to manual hubs, the conversion kit is simply inner and outer spindle nuts and the lock ring washer...most auto parts places carry these also

Amazon.com: Mile Marker 449S/S Lock Out Hub, 1 Pair: Automotive
 

·
Registered
Joined
·
20 Posts
Check out the superwinch manual hubs. 100% no questions warranty. And my friend used the same model lockouts on his 97 that i used on my 99
 
1 - 3 of 3 Posts
Top