Ford Power Stroke Nation banner
1 - 3 of 3 Posts

·
young buck learning.
Joined
·
431 Posts
Discussion Starter · #1 ·
i blew the turbo boot off last night and i went out to fix it this morning but couldnt cause it blew the clamp clean in half. but anyway when i was pulling it in the garage i had the hood opened and noticed smoke coming from the engine bay, so i had a buddy rev the motor while i tried to see where it was coming from, its on the drivers side but i cant tell whether its the manifold or up pipe. the very last exhaust port has a little bit of black around it but it doesnt exatly come from there. should i replace the exhaust manifold gaskets? if the up pipe is leaking how do i stop it?
 

·
The Unseen Mod
Joined
·
4,123 Posts
Actually from the factory there are no exhaust manifold gaskets, you can get them afterwards, but look at your bellows on your ypipe n ypipe contections as well.
 

·
Registered
Joined
·
338 Posts
Also just check the bolts on the exhaust manifold's.
I had a leek that I was chasing for a few weeks and finally found the bolts were just loose.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top