Ford Power Stroke Nation banner

1 - 10 of 10 Posts

·
Busted Knuckles
Joined
·
2,456 Posts
Discussion Starter · #1 ·
Just wondering where I can get the brackets, bushings, and the end pieces that go into the bushings and screw into the ends of the bars?? Thanks for your help!!
 

·
wheres the fat chicks?
Joined
·
1,833 Posts
wandering about this as well
 

·
Registered
Joined
·
301 Posts
I've used Ballistic Fabrication in the past with good results.
 

·
A Ghost these days...
Joined
·
2,434 Posts

·
Busted Knuckles
Joined
·
2,456 Posts
Discussion Starter · #5 ·
Thats exactly what I'm looking to do! About how much did they cost you and what all parts did you have to get.
 

·
A Ghost these days...
Joined
·
2,434 Posts
Thats exactly what I'm looking to do! About how much did they cost you and what all parts did you have to get.
Only money I have in it is for the Heim Joints.
MXM-10 Midwest Control Chromoly 5/8" Rod End
5/8" -18 tpi Jam Nut

If I had it to do over, I would have probably gotten a 3/4" joint. These will be fine though im sure.

~ Solid 1 1/4" o.d. Round Bar = work
~ Drilling / Threading rod ends = work
~ 5/8" x 4" lg studs = work
~ Misc Brackets = cut out at work (lazer cutter)

I dont know if you can tell, but I did most of it for free at work....

I guess I have about $25 tied up in my traction bars.
 

·
Busted Knuckles
Joined
·
2,456 Posts
Discussion Starter · #7 ·
Hmm well I know a guy that has a welding shop and a bunch of machining equipment so i'm sure I could get him to drill and thread the round bar. Thanks for the info man it really helped me out!
 

·
Registered
Joined
·
1,461 Posts
*** has a kit out.
 

·
BRING DA AMBALAMPS
Joined
·
1,951 Posts
poly performance, dirtfab, barnes4wd, and ballistic fab all have the stuff you need.
 
1 - 10 of 10 Posts
Top