Ford Power Stroke Nation banner

1 - 5 of 5 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1
I was wondering if anyone know how to test I Ipr when it is removed from the truck. It's a 95 stroker that's been down for a while. I heard you can run twelve volts to it and should hear a click. I tried this and didn't hear a click but I don't know how trustworthy this info is. Thanks in advance.
-dustin
 

·
Registered
Joined
·
421 Posts
I'm not too sure on that one...... but if it was in the truck you could check the Duty cycle and HPOP pressures with a good scanner..since it is out you might want to replace it or rebuild it however.....
 

·
Registered
Joined
·
16 Posts
Discussion Starter #3
Ok I checked the pressure and it wouldn't even register but I'm un sure if it's the Ipr or the pump itself
 

·
Registered
Joined
·
3,033 Posts
Have you checked to see if the IPR coil is open? In most cases it's not the pump (they are pretty reliable). Cheers!
 

·
Registered
Joined
·
421 Posts
How did you test the pressure ? Mechanically with a guage or electronically with scanner ? Maybe you have a toasted injector o-ring ( or a few ) or other leaks in the HPOP system or you have air in it ?
 
1 - 5 of 5 Posts
Top