Ford Power Stroke Nation banner

1 - 6 of 6 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Ok guys I am so close to getting the intake off but the darn wire harness is in the way. I am not sure of the best way to get this out of the way. I don't want to just go randomly unplugging everything. Can any of you who have done this before make any suggestions?
 

·
Registered
Joined
·
4 Posts
Discussion Starter #3
Cool but not really helpful. However, you guys are amazing. That intake is so cool. I need to stay away from that forum because I am a super rookie.
 

·
Captain Negativity!
Joined
·
3,109 Posts
Cool but not really helpful. However, you guys are amazing. That intake is so cool. I need to stay away from that forum because I am a super rookie.
There was a PDF file attached to the thread with the factory procedure of removing the intake manifold... How is that not helpful?
 

·
Registered
Joined
·
81 Posts
to pull the intake u have to unhook some wiring n sensor plugs i un did my harness and wire tied it up near the harness under windshield the harness is secured pretty tight on the intake but take it slow
 
1 - 6 of 6 Posts
Top