Ford Power Stroke Nation banner

1 - 2 of 2 Posts

·
just a welding fool.
Joined
·
1,097 Posts
Discussion Starter #1
A couple days ago i installed the Turbomaster wastegate controller on my truck. after 2 hours of trying to get the clip on (with the turbo still on) i got so fed up i pulled the turbo off. took me all of 30 seconds to get the clip on and the turbo ready to go back on...:doh:

anyways, i adjusted the spring to what dieselsite gives as the starting point, but when i pin it, i can still reach 30psi without a problem. should i go even less tension on the spring?
 

·
Registered
Joined
·
3,090 Posts
A couple days ago i installed the Turbomaster wastegate controller on my truck. after 2 hours of trying to get the clip on (with the turbo still on) i got so fed up i pulled the turbo off. took me all of 30 seconds to get the clip on and the turbo ready to go back on...:doh:

anyways, i adjusted the spring to what dieselsite gives as the starting point, but when i pin it, i can still reach 30psi without a problem. should i go even less tension on the spring?
If you don't want to see 30 psi, then yes back it off about 2.5783 turns
 
1 - 2 of 2 Posts
Top