Ford Power Stroke Nation banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hello all. I have been having issues with my 97 350 powerstroke. I was getting a crank no start issue for a while, checked everything the internet recommended and finally settled on a bad IDM. Replaced and got it started. Couple weeks later I started having rough idle and hard start condition. I eventually found that the if I touched the power wire (green pin 26) to the IDM, even just barely made contact, the engine would just shut down immediately. I have been unable to source a connector or even a full harness I could cut up, so I'm now wondering if it's possible to just remove and replace the pins in the connector. Looking at it I can't really see how it would go, and have no clue where to look for the proper pins if it is possible.

Does anybody have any insight into this or know of good guides to follow? Or anybody have an IDM connector you'd sell? Thanks in advance for any help.
 
1 - 2 of 2 Posts
Top