Ford Power Stroke Nation banner

1 - 4 of 4 Posts

·
compresion ignition adict
Joined
·
209 Posts
Discussion Starter #1
What are you all doing in regaurds to the IC tubing for your swaps... i plan on building mine but im having a hard time finding the right adapters to make the old 1st gen 12v IC tubes adapt to the 6.0 IC... any suggestions...?
 

·
Registered
Joined
·
18 Posts
Anyone with any answers? I too would like to know what tubing is best to use? Also what about doing something to ends of the tube to keep the houses from blowing off?
 

·
Registered
Joined
·
10 Posts


I used 3" exhaust 90 degree elbows for the driver's side. On the passenger side I used the Dodge pipe, but I had to modify it. From the aircleaner I used the end of a PVC conduit with the bell end and the Dodge flex tube that I cut down. Hope this helps, Stu.
 

·
Registered
Joined
·
482 Posts
[/IMG]

Just hacked up and rewelded a set of 7.3 Super duty pipes for the intercooler piping and praying that they hold lol. Already had the materials for the compound piping done. Should start the first time tomorrow hopefully.
 
1 - 4 of 4 Posts
Top