Ford Power Stroke Nation banner

IC Boot Help

1881 Views 18 Replies 12 Participants Last post by  bigrpowr
Having a hard time keeping the stock boots on with the gt42r and 50psi of boost. IC tubes are stock but the intake Y and intakes are smooth. I just bought some better clamps and hose. I have cleaned and roughed up the clamp area's and tried the hairspray trick.
But here's my question. I'm thinking of welding some wire, about the thickness of a coat hanger, around the ends of the tubes to help keep them from sliding off. Good idea, bad idea?
Any other idea's? Thanks.
1 - 1 of 19 Posts
Like mentioned I would either have a bead rolled in or a welded line 360*. I bought true CAC hose in a 36" stick and use a quality CT hose clamp. Make sure everything is super clean.
1 - 1 of 19 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.