Ford Power Stroke Nation banner
Status
Not open for further replies.

how much pressure can a plastic tank 7.3 ic handle?

2K views 11 replies 7 participants last post by  Short Bus 
#1 ·
anybody? ive got one that i have had sitting around and am thinkin about makin an aftercooler for my air compressor??? 130psi? i figure pvc pipe handle higher pressures and temps than the compressor can produce. was gonna grind off the barbs and glue a pvc reducing cap from the 3" down to 1.5" that the compressor output has.
 
Discussion starter · #6 ·
thats one of the reasons im doin it to catch some of the water. living in the desert before i didnt need an air dryer i do now!! well it was worth an outloud thought

i just figure ive had this ic laying round forever and nobody else wants it

i thought about the copper tubing but the price of 1.5" OUCH!!! i can but an air dryer/aftercooler cheaper
 
Discussion starter · #10 ·
yeah its a big ole pig, 25hp motor on it, its like 65cfm at 100psi. it was one i got at a gov surplus auction couldnt pass it up. its on a 200gallon tank it dosnt have to run very much at all. i was trying to get a small rotory screw with the aftercooler and dryer, but this one was way to good of a deal and it only had 35hrs of runtime on it when i got it.
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Top