Ford Power Stroke Nation banner
Status
Not open for further replies.

how much pressure can a plastic tank 7.3 ic handle?

2K views 11 replies 7 participants last post by  Short Bus 
anybody? ive got one that i have had sitting around and am thinkin about makin an aftercooler for my air compressor??? 130psi? i figure pvc pipe handle higher pressures and temps than the compressor can produce. was gonna grind off the barbs and glue a pvc reducing cap from the 3" down to 1.5" that the compressor output has.
Just get some copper tubing and run it back and forth several times on the wall to cool the air. Make a dip a little lower than lowest point of the tubing and T a drain valve in the line. You will cool the air and trap 95% of the moisture at the drain valve.
 
1.5" damn that must be one mega huge air compressor!!
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Top