Ford Power Stroke Nation banner

1 - 4 of 4 Posts

·
Registered
Joined
·
132 Posts
Discussion Starter #1
I am looking for a part number for the small plug that is in the valley of the engine. Takes a 5/8 wrench to remove. Also you remove two of these to install the cross over hose. Also is this a 1/2" straight thread fitting. I want to pressureize the head to see if I have oil leaking by the injectors back into the head. Thanks Dave
 

·
Crazy Redneck
Joined
·
867 Posts
-05 ORB

If you walk into any hydraulic shop, thats all they need to know, then you can get to most any other thread that you want.

If you need an adaptor, you could say, "I need a 1/8" fnpt x -5 morb"

Good luck

Marc
 

·
Registered
Joined
·
132 Posts
Discussion Starter #3
Marc

That is perfect, Also helps me with the plugs as well. I might even have something kicking around in the toolbox as well.
 

·
dinnerbooter treasurer
Joined
·
3,567 Posts
Hopefully your hydraulic shop is better than the one in our town. They are dumb and couldn't get me the right thing.
 
1 - 4 of 4 Posts
Top