Ford Power Stroke Nation banner

1 - 7 of 7 Posts

·
Mean Green
Joined
·
403 Posts
Discussion Starter #1
lately when I start my truck it will idle fine but when I put my truck in gear and give it a little throttle the truck will jump in Rpm and acts like I floored the pedal for a second but am barely on the pedal. then after that little Buck it will idle funny ( choppy sounding ) and the truck will have no power at all. but besides the funny idle it runs down the road fine no surging or missing, but no power. it acts like my program was removed or like a limp mode or something. anybody heard of this.
 

·
Mean Green
Joined
·
403 Posts
Discussion Starter #3
that's the thing its been throwing a code p2285 which is injector control pressure sensor circuit low. so I changed the icp and the harness myself and still does it. I really don't think I wired it wrong but if I did wire it wrong would it still run?
 

·
Mean Green
Joined
·
403 Posts
Discussion Starter #5
well that's wat I was wandering cuz the harness to my ipr was chaffed and down to bare wire at the end where it plugs into it. I taped them both up but never went any further.
 
1 - 7 of 7 Posts
Top