Ford Power Stroke Nation banner

1 - 7 of 7 Posts

·
Registered
Joined
·
545 Posts
Discussion Starter #1
I have an appointment for sept. 14 to get my ic pipes powder coated and I don't know if I should have them powder coat the ends where the boots go. What did you guys do?
 

·
Super Hauler!
Joined
·
3,882 Posts
i did, then i just roughed it up a little with a scotch brite pad.
 

·
Motorsports Performance
Joined
·
420 Posts
i didnt because if u make boost then its just gonna pop right off a buddy of mine had it happen a couple times till he sanded the ends. so i recommend not doin the ends
 

·
Registered
Joined
·
741 Posts
I didn't. Mark the tubes before you pull them off so you can show them were to not spray. Make sure you do the two radiator brackets also.
 

·
Registered
Joined
·
545 Posts
Discussion Starter #5
Yeah I'll have to mark them and maybe have them go like a 1/4" past the mark to make sure the boots cover.
 

·
Super Moderator
Joined
·
3,401 Posts
Perhaps they can add some sort of grit to the paint. Making the ends rough and helping with keeping the boots on.
 
1 - 7 of 7 Posts
Top