Ford Power Stroke Nation banner

fluidampr Install Woes Day Two!!!

2469 Views 18 Replies 9 Participants Last post by  Aljay
I finally got the dampener back on and now my serpentine belt wont fit between the fluidampr and the pulley on the water pump. So I figure I'll take the water pump pulley off but now the spacer wont come off the pulley shaft only the clutch fan. I'm ready to burn this mother down. No matter how many tools I buy or how many posts I read before doing a project There is always some major malfunction. The older I get the more I understand why people pay to have some one else work on their stuff.

I have never seen A post about problems getting the belt back on after the fluidampr install. God forbid what will happen if I ever throw a belt going down the highway I'll never get a new one back on.

1 - 1 of 19 Posts
I had no issues installing mine.. just had to move the radiator a bit to get my impact in to get the bolt out, then used a puller...

I had read somewhere that people used an axe in the flywheel teeth to tighten the bolt, so I did that very carefully... it was nerve wrecking though... but I know for a fact that it is to 212Ft-lb
1 - 1 of 19 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.