Ford Power Stroke Nation banner

1 - 2 of 2 Posts

·
Landscaper Dan
Joined
·
2 Posts
Discussion Starter #1
I'm new to this site so hopefully I'm in the right place. My truck is 99 F-450 Cab and Chassis up-fitted with an 8x12' flat dump. Manual hubs, transmission and transfer case.

When I shift into 4WD high, the shifter falls back into 2WD. It will stay in neutral and low 4WD. I climbed underneath and nothing looks out of place, but the post on the top of the pivot shaft fails to pivot into the detent. If I hold the shifter in place with my hand, 4WD works just fine.

I rebuilt this motor so all components have been out and reinstalled so this may be an installation error on my part.

Any Ideas on this out there?
 

·
Landscaper Dan
Joined
·
2 Posts
Discussion Starter #2
No Answers. Does anyone know a way to et the factory blow up diagram of transfer case shift assembly?
 
1 - 2 of 2 Posts
Top