Ford Power Stroke Nation banner

1 - 5 of 5 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter #1
What should be the ebp readings on my 6.0? My sct livewire only shows psi on the pid. It reads whatever my boost psi is. If my boost is 0 then ebp shows 0 and so on. Has a non vgt turbo on it. Any suggestions?
 

·
Registered
Joined
·
42 Posts
it should be more than the boost.
 

·
Registered
Joined
·
1,419 Posts
Honestly, it varies quite a bit and will change based on engine speed, load, and so on. Also, depending on how your PIDs are configured, you could get a couple different readings....might show around 14PSI with everything off, or might show zero. That will affect the rest of the readings, of course. Mine would show zero with engine off, and about 15 at idle, with it increasing to around 50 during higher throttle. (I think....it's been a while since I've looked) However, it shouldn't matter to you at all. The only reason that's of any real value is for the VGT. If you have a non-VGT turbo, who cares what it is? Unless you're just curious.
 
1 - 5 of 5 Posts
Top