Ford Power Stroke Nation banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,586 Posts
Discussion Starter · #1 ·
Buddy had an open house yesterday and so I put my truck on the dyno to get a baseline before I start going into more mods. It was my first time running on a dyno so a bit of a learning curve for me and it was an unloaded dyno. Truck specs are in my sig. Ran it in the Street Fury tune from Gearhead and basically did a boosted launch since the couldn't load it. Got it up to around 12psi of boost and dumped the brake and go fuel to the floor. Best run was 305HP with the tune, exhaust, and intake. We are thinking if it would have been loaded it would have been around 330 maybe. Just thought it may help some of the others out to see where they were with mostly stock trucks since I see the question come up a lot. A friend with same mods and all as me ran in the All Out gearhead tune and did 275HP so the higher setting may hurt you sometimes.
 

·
Registered
Joined
·
1,586 Posts
Discussion Starter · #3 ·
No torque reading on the dyno. Broke the sensor the night before.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top