Ford Power Stroke Nation banner

1 - 7 of 7 Posts

·
Registered
Joined
·
116 Posts
Discussion Starter #1
I when i purchased my truck i was told it needed a clutch, so i bought the conversion kit to a regular fly wheel.

When i dropped my tranny i realized the clutch, and flywheel were in good shape, the through out bearing went out and caused damage to the pressure plate.

I had already purchased my new flywheel/ clutch kit so i went ahead and installed it.

Is my dual mass flywheel worth anything to anyone?
 

·
Demon Dually
Joined
·
5,140 Posts
Scrap steel??:poke:
 

·
Registered
Joined
·
202 Posts
could make a nice john boat anchor
 

·
Registered
Joined
·
116 Posts
Discussion Starter #4
That is exactly what i was thinking but i did not want to chunk it and it be of some value to someone else.
 

·
Registered
Joined
·
202 Posts
ah all psd guys need to convert to single mass, so one less dual mass is ok ;)
 

·
Registered
Joined
·
797 Posts
I'm wondering if I could make mine into an isolation pad for my stereo turntable, after I press off the ring gear and take the center section out.

That's the only use I've thought of so far!
 

·
Fixing Broken Stuff
Joined
·
2,078 Posts
In my area it worth about $220 a ton or .11 per pound. Well if its good you could ebay it, somebody someware wants it
 
1 - 7 of 7 Posts
Top