Ford Power Stroke Nation banner
1 - 6 of 6 Posts

·
Registered
Joined
·
254 Posts
Discussion Starter · #1 ·
Need some help. I made some up pipes and pedistal for my HX50 on my spare 97 engine and went to bolt it to my truck and it didn't fit:confused: Looked into it and found the spare engine is out of a van. By looking at it, the only differance is the left side, the right sides look the same? does this sound right. I want to pull the manifold off the truck and bolt it to the spare engine and then redo the pipes again. I don't want to pull the engine out of the truck just to make up pipes! :fordoval:
 

·
OEM Moderator
Joined
·
9,379 Posts
Can you compare the casting/part numbers on the manifolds so you know 100% that only that one side is different?


Tom
 

·
Registered
Joined
·
254 Posts
Discussion Starter · #4 ·
Both engines are out of a 97, spare engine is out of a van. I didn't think of something as simple as looking at the casting numbers. I guess when you spend two days makeing up pipes that dont fit you don't think right! I will check today and let you all know! Thanks
 
1 - 6 of 6 Posts
Top