Ford Power Stroke Nation banner

1 - 6 of 6 Posts

·
Registered
Joined
·
120 Posts
Discussion Starter #1
I was driving home tonight and glanced over at the dash daq and noticed that the EGRTA and EOT temps were not being read. All other gauges were actively reading. I had to turn the dash daq off and back on for it to start reading again. Anyone else had this happen? Any suggestions on what could have caused this?
 

·
Registered
Joined
·
544 Posts
Do you leave it on all the time? I have had it act goofy if I am a little slow turning it to standby after I shut the truck off.
 

·
Registered
Joined
·
9,722 Posts
I have had this happen a time or two when I leave the DashDAQ on, shut the truck off for a few seconds, and then crank the truck back up without letting the DashDAQ catch up.
 

·
Registered
Joined
·
120 Posts
Discussion Starter #5
I have had this happen a time or two when I leave the DashDAQ on, shut the truck off for a few seconds, and then crank the truck back up without letting the DashDAQ catch up.
Think you nailed it... Had to shut the truck off at the drive thru. Will have to keep an eye out the next time I'm in the drive thru and see if it happens again.
 
1 - 6 of 6 Posts
Top