Ford Power Stroke Nation banner

1 - 8 of 8 Posts

·
Registered
Joined
·
59 Posts
Discussion Starter #1
i have a 1993 and 1997 d50 that im about ready to send to scrap... what parts should i keep that i can use on my 1995 d60?
 

·
Demon Dually
Joined
·
5,140 Posts
Hubs, rotors, and lockouts.
 

·
Registered
Joined
·
59 Posts
Discussion Starter #3
thanks
 

·
Shortbus driver
Joined
·
223 Posts
Keep the spindles too! They aren't exactly the same, but they work very well - especially on the balljoint d60s, as they dont use a caliper bracket.
 

·
Registered
Joined
·
59 Posts
Discussion Starter #5
ahh good to know... thanks
 

·
Registered
Joined
·
32 Posts
stub axles, u joints, calipers also
 

·
Registered
Joined
·
2,761 Posts
Keep the spindles too! They aren't exactly the same, but they work very well - especially on the balljoint d60s, as they dont use a caliper bracket.
The ball jointed spindles are the same. The kingpin spindles have a longer pilot to get through the caliper bracket.

Billy T.
[email protected]
 

·
Registered
Joined
·
2,761 Posts
stub axles, u joints, calipers also
The calipers are different between a '93/'94 vs '95-'97 era trucks. The early trucks used slide pin calipers while the later model trucks used the bolt on caliper. Also the earlier era trucks had a slighly smaller rotor.

Billy T.
[email protected]
 
1 - 8 of 8 Posts
Top