[TX_S]

What are the chances that the cps going out would cause a no start and other codes? It will start after cranking it two or three times but once it warm it won't start again without setting for atleast an hr or so. And does anyone know the procedure for swaping it out, I know on the obs u have to pull a fuse.
Thanks
Andrew

 

[CTC DEEZUL]

this is a high pressure oil system leak.... Its best to get er to act up, pull valve covers, and pressurize the HPO system wit shop air and listen for leaks. commanding the IPR closed is also advised....

 

[TX_S]

What exactly is ipr?

 

[CTC DEEZUL]

mouse over the green letters.... it controls the oil flow, it has to be commanded closed in order to hear leaks in the system.... this can be achieved by using IDS, or back probing the 2nd plug on the ecm, red/yellow wire, puttin it to ground, than keying on...

 

[TX_S]

Ok thanks