Ford Power Stroke Nation banner

1 - 6 of 6 Posts

·
Banned
Joined
·
780 Posts
Discussion Starter #1
so i came over the pass this morning and it was snowing the entire way with around 6" on the ground. i needed to run the 4x4 a few times... well i toasted my front cv joint on the front driveshaft from the angle with an 8" lift on my truck. so anyone know where i can get a high angle setup without getting completely rapped????
 

·
<<< THE GAUGE WHORE...
Joined
·
12,082 Posts
I'm thinking your going to get raped on it no matter what...
 

·
Banned
Joined
·
780 Posts
Discussion Starter #3
yea average seems to be around 400 from tom woods driveline and high angle driveline
 

·
<<< THE GAUGE WHORE...
Joined
·
12,082 Posts
yea average seems to be around 400 from tom woods driveline and high angle driveline

Can they make it work without shimming the Axle and all? Thats not bad...
 

·
Banned
Joined
·
780 Posts
Discussion Starter #5
489 for a 32 degree one.. high angle driveline. guy said that the 99-01 front driveshafts are built by saginaw and are junk and he was not suprised that i ate it up and that it was good that i pulled over when i did otherwise id be looking for a tcase and tranny.
 
1 - 6 of 6 Posts
Top